Home -> Attach Fiberglass Grating -> Attach pultruded Fiberglass Grating to Fiberglass Structure

Attach Pultruded Fiberglass Grating to fiberglass structures.

Model FSSGF-1C

Fastens pultruded grating to a horizontal-facing, fiberglass structural member edge.

The model FSSGG- describes an assembly of three parts. First is a G-Clips unique and patented top for better holding strength and to suit I-6000 pultruded grating. Second, a G-clips patented bottom connects to the beam underside. A hex-headed cap screw connects the two, and its length suits the grating height being installed.

How to install
G-Clips can be installed from above the grating, by one person, unassisted, and using simple hand tools. A 7/16" nut driver is most often used. Powered tools are not necessary, but electric or air driven tools can be used with torque limits.

Quantities recommended
We recommend using a grating fastened point for every four (4) square feet of grating, in average, pedestrian conditions. Where vibration is present more fasteners should be used. Grating manufacturers recommendations should be consulted for further information.

Ordering information
Determine grating size. Order (quantity required) Model FSSGG- fasteners to suit (grating height) onto beam edges (range of thickness at member edge).

Generous quantities of popular sizes are usually in stock and can be shipped same day if ordered before 2:00 p.m. CST.

Sizing Chart:

Other sizes are available from stock. Please consult our technical department via e-mail.

Top of page.